Saturday, 18 June 2011

Browse » Home » » » » » Nokia X5-01 Ringer Buzzer Speaker Troubleshooting

Nokia X5-01 Ringer Buzzer Speaker Troubleshooting

Here's the solution which can help solved and fix Nokia X5-01 with a not working buzzer or ringer speaker problem.This problem may happen if the device suffered wet or damaged and or accidentally dropped.

If the Nokia X5-01 ringer speaker has no sound can be heard over it, this may be possibly caused by a damaged buzzer speaker, a loosen contact of the speaker's terminal pads, and or some possible damaged components inside the Nokia X5-01 PCB circuit board.

In troubleshooting speaker problem on nokia X5-01, you may need to check the speaker if it still working or not, then replace it if found damaged. 
You may also ensure that the speaker terminals are not misaligned and the terminal contact pads on the PCB board were also cleaned.

The solution below will show the location of the components on Nokia x5-01 PCBcircuit board that may need to check, trace for further troubleshooting if the above steps has already been made but still doesn't fix the problem.

The above solution shows the line paths of the ringer speaker connection through each corresponding components, you may need to check trace the connection line paths and components. Replaced particular components if found already damaged and apply a jumper wire if there is an open or cut-off connection.
On this procedures might only fix the Nokia X5-01 ringer speaker problem. 

No comments:

Post a Comment

Note: only a member of this blog may post a comment.